High pressure pump manufacturers tell you, magnetic drive of non-metallic high-pressure pump knowledge

Basic information to be mastered before and during the use of pressure test pump: before the pressure test pump is started, it shall be comprehensively inspected, and all components, their connection and pressure shall be checked. No access. In order to improve the pressure test efficiency of low-pressure fuel pump, the tested object can be filled with water first, and then the outlet pipe of the pressure test pump can be connected, so that half the effort is twice as good as possible.

If air or water is found in water during pressure test of high pressure test pump, it can be continued after it is solved. It is important to remember that the pressure is not allowed to continue when adding water. After pressure test operation is completed, the drain valve must be released first to close the equipment after the pressure drops to protect the pressure gauge from damage.

The magnetic driven non-metallic high pressure pump is also very careful in the process of material selection. In order to reduce cost and ensure safety, widely available building materials are used. After reasonable design, a kind of non heat and low power consumption operation equipment is obtained. This pump is most commonly used in steel manufacturing enterprises, mainly in the acid pickling process, because it has good chemical resistance.

Because the non-metallic magnetic drive high-pressure pump has good torque transmission, that is, it can increase viscosity even at low ambient temperature, so its performance is not easily limited by environmental factors. Reliability of safe operation of high pressure pump equipment. In order to ensure the safe operation of pump equipment, the management of pump equipment is more standardized. Annual overhaul, monthly secondary maintenance and daily maintenance system are all measures to ensure the safe operation of pump equipment. In order to ensure the reliability of safe operation, the training and improvement of the technical quality of operators and the implementation of safety operation regulations must be strictly implemented. The implementation of these safe operating systems is the guarantee of the reliability of the pump equipment.